Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| bms:replacement [2025/03/13 06:19] – [1. Minimum Requirements] admin | bms:replacement [2025/03/13 08:11] (current) – removed admin | ||
|---|---|---|---|
| Line 1: | Line 1: | ||
| - | ====== Guide to Replacing a BMS-EX on-site ====== | ||
| - | |||
| - | This guide details the necessary steps to replace a BMS-EX on-site while preserving the data and settings from the BMS to be replaced. | ||
| - | |||
| - | ===== 1. Minimum Requirements ===== | ||
| - | * Old BMS must be EX series. | ||
| - | * Old BMS must be online and visible on the logger. | ||
| - | * Old BMS firmware version is 202 or greater. Update if necessary. | ||
| - | * Logger software version is V9.121 or greater (update if necessary). | ||
| - | {{: | ||
| - | ===== 2. Replacement ===== | ||
| - | * The old BMS may now be removed, and the new BMS installed in its place. | ||
| - | * Verify the BMS is securely installed and that all connectors are seated correctly. | ||
| - | * After switching the new BMS on, it should start up and remain in an error state until the replacement process has been completed via the wizard. The CANBUS 1 interface on the new BMS should show activity (blinking green LEDs). | ||
| - | |||
| - | ===== 3. Configuration ===== | ||
| - | * Navigate to **MyPower24 → My Devices → Li-ion Storage EX Series**. Click on the orange service alert icon. (*1) | ||
| - | * A dialog box will tell you that the logger has detected a replacement BMS. Click to continue. (*2) | ||
| - | * A dialog box will open asking you to type in the serial number of the BMS that was replaced. Once populated, click '' | ||
| - | * Once the process is complete, the battery will appear online. | ||
| - | * The old BMS should be returned to SolarMD. | ||
| - | |||
| - | {{ : | ||
| - | |||
| - | {{ : | ||